Nameplates

[AmbroseJackus]

Enemy Nameplates being too low and covering Enemy
Hello.

I've been having the problem ever since I downloaded the WOTLK Client where the Enemy Nameplates are covering the Enemy too much.

Examples can be found in these screenshots:

Not Enabled - https://gyazo.com/184010c2dcf6d7f51e27acd7c70b6754
Enabled - https://gyazo.com/e42b93645d55e0d52ea2a1d99add047e

I've tried to fix it by doing the following:

Turn off all addons.
No addons, and Interface/Video settings to default.
Removed all folders pertaining to settings/config (only Data and .dll files left in WoW folder).

Currently going to try (EDIT: tried):

Downloading client again, and start up fresh. Did not work.

This bug persists through both clients of WOTLK. Old and new models.

Any suggestions? Thanks.

I'm pretty sure everyone that uses the default nameplates has this issue, any way to fix it?

[OhieMitzen]

IIRC WotLK nameplates are bit dated in terms of what can be done with them. You can make them marginally better with addons. Beyond that, there's not much what you can do about them.

[AmbroseJackus]

Well duh, I mean what I'm trying to achieve is to just move the nameplates a little higher so they aren't inside the players penetrating them, and I know you can do that with a bunch of addons like Tidyplates etc, but I'm trying to find one that will let me move the bars up while still keeping the default blizz ones..


I'll pay 10k gold or boost to 1.8-2k 2v2 ICC horde, any nubcake that solves this issue for me

[OhieMitzen]

Well duh

Well, well duh. Well duh you could've read the replies on the thread you copied your post from.

WotLK Enemy Nameplates being too low and covering Enemy

[AmbroseJackus]

Rofl, hey now, was faster and easier that way, figured 6-7 years later tho someone would figure out a way to do the nameplate thing